Connect the XSR-SIM USB dongle to the computer and bind it to your transmitter (D16, CH1-8, no telemetry). OpenTX: Create a new fixed-wing model in your transmitter. Then limit the servo TRAVEL in the MODEL > END POINT menu for channels 1 to 8 to -038 -060. Set channels 1 to 8 to +100 in the MODEL > SUB TRIM menu in the transmitter. Take a look at the input monitor and move your sticks. It is necessary to adjust the servo center point and travel on your transmitter. Set it to 1 or higher for other dongles.įrOS: Create a new fixed-wing model in your transmitter. When using an RX2SIM, the value 0 is perfect. As a rule of thumb, the poorer the signal quality, the larger the deadzone. Select your stick mode also in settings > output device. The sticks shown at the bottom of the screen will guide you visually and display the requested input.
XTR RC FLIGHT SIMULATOR SIMULATOR
Just click onto start calibration and follow the instructions and the simulator calibrates the output to -100 / 0 / +100. You can disable any undefined or flickering channels. In our example we use a Futaba FX-30 and haven't changed any center or travel adjustment. Reduce the servo travel in your transmitter if the input monitor shows + or -100 before your sticks reach their Your USB interface may be incompatible when you have tried all other channels without getting a response in the input channel overview. For Futaba you can do this easily in the transmitters function menu. If not, you have to change the channel in your transmitter to an other channel. Each function (collective pitch, rudder, aileron and elevator) should move a slider. The input monitor window displays the incoming remote control signals. Only if it does the transmitter is working in trainer mode.
XTR RC FLIGHT SIMULATOR MAC OSX
Start calibration and follow the instructions thereĪn FMS compatible USB dongle is compatible with Windows as well as with Apple Mac OSX computers. If not, please follow the instructions below. Up to 20 channels are possible depending on your dongle The control input monitor window displays the raw control signal data. We recommend using wireless adapters such as the RX2SIM.